AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (1151-1200 of 1334)
Click title to read one, or click date to read all below it.

02-24-12   This is possible paul, but thermal inter-channel drift is on ...   Georgelofi

02-25-12   I have both the bent and the lsa and plan to do a detailed r ...   Vicks7

02-25-12   Vicks7: which bent do you have? autoformer or s&b tranies?   Devilboy

02-25-12   I did mean possible "drift" i did not mean to sugg ...   Pubul57

02-25-12   I have the tap-x.   Vicks7

02-25-12   If you bought it within the past 18 months direct it probabl ...   Pubul57

03-07-12   I'll ask it here, not because it is exactly on point, but th ...   Pubul57

03-07-12   Hi, i used to own the very highly regarded first sound (acti ...   Kevinzoe

03-07-12   That is what i suspect, 2db would not be as useful as one wo ...   Pubul57

03-07-12   Yes 2 db could be problematic in some instances. the 24 step ...   Clio09

03-07-12   Given the necessary taper for stepped attenuators and the ex ...   Pubul57

03-08-12   The mla is in production as is the voltage adjustable otl pr ...   Clio09

03-08-12   Yes, the tap x is auto former - slagle.   Vicks7

03-08-12   That's good, i thought the slagle avc was preferable to the ...   Pubul57

03-08-12   Hasn't made the website yet, but working on it. we need to o ...   Clio09

03-08-12   Very cool. i'll be calling:)   Pubul57

03-14-12   Just bought a lsa and got hooked up for 5 hours. got the bes ...   Tristone

03-14-12   Less is more when it is enough.   Pubul57

03-14-12   Just in case some are wondering, tristone (lei) ordered a du ...   Georgelofi

03-14-12   Nice gesture to the diy crowd!   Pubul57

03-15-12   That's funny george... every so offen i switch between my au ...   Ts0711

03-15-12   I think i could only deal with dual mono controls with steps ...   Pubul57

03-29-12   Just picked up a lightspeed. here's what i have,how can i ge ...   Gooddomino

03-29-12   The input sensitivity and input impedance of your amp are fi ...   Clio09

03-29-12   Clio - looks like the output impedance is 600 ohms on the re ...   Gooddomino

03-29-12   Hi gooddomino, what is the model number of your rega dac. ...   Georgelofi

03-29-12   I had to look at the stereophile review of the rega dac to f ...   Georgelofi

03-29-12   What is low capacitance? under 100pf? 200?   Pubul57

03-29-12   George, i'll have to shoot rega an emai. none of my ic's are ...   Gooddomino

03-29-12   No 1 meter ic i know is likely to create any capacitance iss ...   Pubul57

03-30-12   Any cable that is below around 150pf (picofarad) per foot is ...   Georgelofi

03-30-12   I think your audience cable would work fine as i recall it t ...   Clio09

03-30-12   Anthony those are rca? i use mogami xlr with that atma-sphe ...   Pubul57

03-30-12   Clio - looks like the output impedance is 600 ohms on the re ...   Gooddomino

03-30-12   Clio might be out and about, but on the famous diy thread, g ...   Pubul57

03-31-12   Yes i use mogami rca's from the lsa to my rm-10.   Clio09

03-31-12: Pubul57
34 or 49?
Pubul57  (System | Threads | Answers | This Thread)


04-01-12   2549, two conductor with shield. the two conductors are sold ...   Clio09

04-05-12   Has audiogopn made it impossible to get, and use, e-mail con ...   Pubul57

04-05-12   Basically. not sure if or when that feature will be coming b ...   Clio09

04-05-12   Yes, this is really to bad and a seriously poor decision. th ...   Grannyring

04-05-12   I don't understand it, it is certainly not a privacy issue i ...   Pubul57

04-05-12   I completely agree. it's a shame they've removed the ability ...   Mingles

04-06-12   Well perhaps the email capability will return in the near fu ...   Clio09

04-06-12   Hi all, as a lightspeed customer i came across someone sayin ...   Kevinzoe

04-06-12   Kevin, you have a link to where that was said?   Pubul57

04-06-12   hi kevin, the distortion that the nsl32sr2s ldr's is .02%. ...   Georgelofi

04-06-12   Hi - with my lightspeed i still get significant volume when ...   Gooddomino

04-06-12   Could also be that your amp is very sensitive and/or has hig ...   Clio09

04-07-12   Or you could try a pair of the rothwell inline rca attenuato ...   Georgelofi


< Prev << 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password